english 
When using a ball valve pneumatic actuator,
several safety precautions should be taken to ensure its proper operation and
the safety of personnel and equipment:
Pressure regulation: Always ensure that the
air supply pressure is within the specified range of the actuator, usually 6 -
8 bar. Excessive pressure can cause the actuator to malfunction, leak, or even
burst, posing a safety hazard. Install a pressure - regulating valve and
monitor the pressure regularly.
Inspection and maintenance: Regularly check
the actuator for signs of wear, damage, or leakage. Inspect the seals, hoses,
and fittings for any signs of deterioration. Replace any damaged components
immediately to prevent air leaks and ensure proper operation.
Lockout - tagout procedures: Before
performing any maintenance or repair work on the actuator, follow proper
lockout - tagout procedures. Shut off the air supply, relieve any remaining
pressure, and lock the valve in the closed position. Place a tag on the valve
to indicate that maintenance is being performed to prevent accidental
operation.
Personnel training: Ensure that all
personnel who operate or maintain the ball valve pneumatic actuator are
properly trained. They should be familiar with the operating procedures, safety
precautions, and emergency shutdown procedures.
Safety devices: Install appropriate safety
devices such as limit switches to indicate the valve's position and prevent
over - travel. Also, consider using pressure - relief valves to protect the
system from over - pressurization.
If you want to learn more about low-priced products, please visit the following website: www.xm-valveactuator.com
